The LTE Cell Table will display the data as follow:

3GPP Band Number: LTE band definitions.

MIMO Diversity (Tx/Rx): this attributes shows eNB antennas number of Tx and Rx.

EARFAN DL/UL: EARFCN of Downlink and Uplink

Carrier RSSI: RSSI of E-UTRAN

Bandwidth DL/UL: This attribute gives the downlink bandwidth of the cell the UE is camping on. Carrier Aggregation (LTE Advanced): In CA mode, this attribute gives the downlink bandwidth of Primary Cell (PCC).

PUSCH/PUCCH Tx Power: This attribute is the geometric average (average in the dB domain) of the UE transmit power, only considering the transmission time intervals where the UE transmitted. The contributions of PUSCH, PUCCH and SRS are included in this attribute. The unit is dBm.

PDSCH BLER: This attribute gives the Block Error Rate defined as the ratio of the number of transport blocks successfully received to the total number of transport blocks received by the UE.

Timing advance: LTE Timing Advance Information. The range for this attribute is 0 to 1282 in units of 16xTs (LTE time units).


LTE Cell table

Up to eight cells are displayed, each belonging

to one of the following categories:

• S: Serving cell (non-CA)

• P: Primary serving cell (CA)

• S1: Secondary serving cell (CA)

• N: Measured neighbor (always used).

Serving cells are prioritized above neighbors, the latter being displayed as far as space allows. Within each category, cells are sorted by descending RSRP.

RSRQ: This attribute gives the Received Quality of the Reference Signal for the cell the UE is camping on. The unit is dB. Carrier Aggregation (LTE Advanced): In CA mode, this attribute gives the Received Quality of the Reference Signal of the Primary Carrier (PCC).